Today, I will be explaining to you how to program your Samsung Soundbar Remote codes by presenting various methods you can take to achieve it. You will need codes to carry out some of the methods I am going to present, therefore, the codes below are very important:
Table of Contents
5 digit remote codes for Samsung Soundbar Universal Remote
- 32609
- 22609
- 32660
- 31949
- 21014
- 20045
Samsung Soundbar codes for Spectrum Remote Control
13993, 10060, 11959, 10766, 11480, 10814, 10178, 22660, 21868, 22137, 22241, 12051.
GE Universal Code for Samsung Soundbar
- 0454, 0942
The codes above can work with the entire models that are listed below:
- HW-J355
- FM550
- HE550
- HW-H550
- HW-H7500/ZA
- HW-HM55C
- J650
- HW-F450
- WH-E450
- HW-J355
- FM550
- HE550
- HW-HM45
- F550
- J450
- HW-E450.
How to Program the Samsung Soundbar Universal Remote Without Codes
If you want to program your Samsung soundbar universal remote without codes, all you need to do is follow these steps accordingly.
- Switch on your Device e.g. TV so you can operate it.
- Turn on your remote control and tap on the device button on it e.g. TV, DVC, and so on for 3 seconds until an LED light blinks to indicate that your remote is ready to program.
- Point the Universal remote on the device and press the CH+ and CH- buttons. Your remote will show on and off signals. Press the up or down button continuously until your TV or the selected device turns off.
- Verify the code by clicking on the power button of your Universal Remote, if it starts up your device, try to change the channel to verify that the code is correctly programmed.
- Tap the device button to save your new code. If an LED light blinks twice, that means the code is now stored.
That is the easy way to program your remote using a method that does not involve using codes. In the next steps, we will look into the steps that involve code.
How you Can Program Samsung Universal Remote Codes Using the Manual Steps
These steps are important when you are intending to program your Samsung Soundbar Universal Remote. Here are the instructions needed to make this happen:
- Turn on your device, e.g. TV.
- Press the TV button on your Samsung Universal Remote Control.
- Press and hold the setup button on your universal remote until you can see the flashlight to activate it to learning mode.
- Enter the provided key code in your remote’s instruction manual.
- After that step above, point the remote to your TV and then press and hold the power button.
- Once the TV switches off, release the power button.
The universal remote programming method is also effective. If you can follow it properly, that means the codes will work with your universal remote.
How you Should Program your Samsung Soundbar Universal Remote Code
This method is applicable with the Samsung Soundbar Universal Remote code. This method is workable when done correctly.
- Turn on your device to get it ready for programming.
- Turn on the remote control as well.
- Press and hold the setup button on your remote control
- Enter the unique 9 9 1 codes
After that, you should hold down the power button on your remote and then press the channel up button until the TV turns off since we are working with TV in this article.
These are the best methods you can always adopt when programming most of your universal remotes. They work effectively. You can try them one after the other if eventually one of the codes does not work until you finally find one that works with your remote.
No Responses